CHARACTERISTICS
Plaster for walls and ceilings.
Floated finish.
Floated finish.
Waterproof.
Projectable.
Projectable.
APPLICATIONS:
Finished plaster finish.
Water-repellent mortar to cover walls.
Indoor and outdoor.
Permeable to water vapor.
Water-repellent mortar to cover walls.
Indoor and outdoor.
Permeable to water vapor.
SUPPORTS:
Factories of bricks, precast concrete block and cement plasters.
The support must be flat and absorbent in addition to having good resistance.
With bonding bridge: smooth concrete.
Consult other supports.
Not admissible: plaster or plaster supports, painted supports, waterproofed supports and, in short, any support that does not present good absorption and acceptable consistency.
The support must be flat and absorbent in addition to having good resistance.
With bonding bridge: smooth concrete.
Consult other supports.
Not admissible: plaster or plaster supports, painted supports, waterproofed supports and, in short, any support that does not present good absorption and acceptable consistency.
COMPOSITION:
White and grey cement, siliceous and / or calcareous aggregates and organic and inorganic additives.
PREPARATION OF THE MIXTURE:
With a spraying machine, adjust the mixing water until obtaining a plastic and thixotropic mass.
With manual preparation the water dosage: 21% ± 2% (± 5 liters/sack).
Knead until you have a homogeneous paste and let it rest for 3 to 5 minutes.
Yield approx. for 1mm thick 1.8 Kg / m²
With manual preparation the water dosage: 21% ± 2% (± 5 liters/sack).
Knead until you have a homogeneous paste and let it rest for 3 to 5 minutes.
Yield approx. for 1mm thick 1.8 Kg / m²
PRODUCT APPLICATION:
Spread the product with a trowel, pressing firmly leaving a thickness of 2 / 3mm and then apply to the desired thickness.
Once partially hardened, float.
For a finer finish after trowelling, trowel again and / or brush the surface.
Application thickness not exceeding 20 mm.
Once partially hardened, float.
For a finer finish after trowelling, trowel again and / or brush the surface.
Application thickness not exceeding 20 mm.
RECOMMENDATIONS:
Do not apply in rain, strong wind or direct sunlight.
Respect the instructions for use.
For more information request technical data sheet and or safety.