CHARACTERISTICS
Thick layer tiling.
Without picking up.
Up to 30mm.
APPLICATIONS:
Glue mortar for laying ceramic tiles in a thick layer indoors.SUPPORTS:
Cement-based floors.
Walls: plastered with sand and cement, brick factories, concrete blocks, etc.
With bonding bridge: smooth concrete.
Consult other supports.
COMPOSITION:
Gray/white cement, siliceous and/or calcareous aggregates and organic and inorganic additives.
PREPARATION OF THE MIXTURE:
Water dosage: 22% ± 2% (± 5.5 liters bag).
Knead until you get a homogeneous paste and let it rest for 3 to 5 minutes. Mix again.
Yield approx. 12/14 Kg/m².
Knead until you get a homogeneous paste and let it rest for 3 to 5 minutes. Mix again.
Yield approx. 12/14 Kg/m².
PRODUCT APPLICATION:
Spread the product in the traditional way by solidifying the piece. Previously, a thin layer will be applied on the support to achieve optimal adhesion.
Lay the tiles and press until you get a good settlement and distribution of product.
It is mandatory to leave joints between tiles of at least 2 mm in interior.
For an optimal settlement of the product it will not be possible to transit in the following 3/4 days.
RECOMMENDATIONS:
Respect the mixing water.
Application temperature should be between 5ºC and 30ºC.
Protect from wind currents.
For more information request technical data sheet and or safety.
Respect the mixing water.
Application temperature should be between 5ºC and 30ºC.
Protect from wind currents.
For more information request technical data sheet and or safety.